-
Thirty-two cents or five dollars: what a sheathing robot's fixes cost on real studs
On real studs, fixes lifting a sheathing robot from 43% to 77% clean sheets cost 32 cents; a doubled joint stud costs $5.13 more a sheet.
-
A bowed stud closes the sheathing joint, and a better robot can't reopen it
At published 2x4 warp a nailing robot reading each stud three times gets 80% clean sheets, perfect sensing 87%; a 3x or doubled joint stud gets 100%.
-
A stock humanoid can press the sheet, but it can't carry it there
A G1 holds 8.7 kg at most and an H1 18.8 kg, short of a 21.8 kg OSB sheet, but on a ledger both press it and their stock gains let the ledger square it.
-
A ledger board squares the sheet, if the robot lets go
In MuJoCo, a sheet set on a ledger and released seats to 0.0001° if the robot presses under ~100 N; then the panel's PS 2 squareness is the limit.
-
What does a robot-nailed sheet of wall sheathing cost?
A G1 on a lift base is the cheapest sheathing robot below about 500 houses a year and beats a hand crew in 37% of draws at 100. The extra stud does not pay.
-
What a clean sheet of sheathing costs a robot, in seconds
With placement, sensing, nailing and rework charged, doubled joint studs and one read a stud give 99.97% clean sheets in 76–216 s; single 2x costs 18–65 s more.
-
Does a sheathing robot's ledger trick survive a second physics engine?
Rebuilt in Drake, a sheathing robot's ledger seat still squares the sheet; clean sheets move 0.06 points at most. The bowed-edge rock depends on the engine.
-
A paper draft on robot wall sheathing, and the five hypotheses scored
Seven milestones on robot wall sheathing as one paper draft: three of five pre-registered hypotheses held, one in half, one only for one stud reader.
-
Tack, then measure: how coarsely may a sheathing robot hang the sheet?
A sheathing robot that tacks and measures may hang a sheet to 0.54° and 10 mm on doubled joints; single 2x joints need 0.03° and 0.4 mm.