When the Door Is as Tall as the Wall: framing takeoffs from messy BIM models

Four walls in a real house model were refused: the header was deeper than the room under the plates. A new flag swaps in the deepest header that fits.

Running a whole-house model through the wall framing takeoff turns up facts no hand-typed plan has. In OpeningDesign's Schultz Residence, a door is 85-1/2 in tall under a plate line at 85-1/2 in. A 2x10 header cannot go there, so the engine refuses the wall, and --skip-refused drops it from the order.

The new --shallow-headers flag handles that case. It picks the deepest listed header (2x10, 2x8, 2x6, 2x4) that fits under the plates, keeps the opening as modelled, and prints a note for each swap. If nothing fits, the wall is still refused. It does not check the span, so a 2x4 over a wide door is a prompt to look at the model, not a design.

It is tested on a hand-built wall, not yet on the Schultz file. Details are in the venture's README.

All writing · More in Tools and projects · More on Wall Framing Takeoff · All tools and research