The tennis-ball feeder's take-up track: the ties are fine, the hose pull is the unknown

A statics check on the two brackets that tie the feeder's hose take-up track to its hopper frame, and what it says about what to measure first.

The open tennis-ball feeder needs a spring-loaded pulley that takes up about 258 mm of hose slack as the launcher head tilts. That pulley rides a 489 mm 2040 track, and the track has to be tied to the hopper frame.

Feeder.track_tie now works out the loads on those two ties. The spring balances twice the 5 N hose tension. With a 3x allowance for the hose snatching, that is 30 N along the track, 55 mm off its centreline. Each tie takes 15 N in shear and a 3.8 N pull from the couple. An assumed 400 N M5 slot nut therefore has a factor of about 104 against the 3 wanted.

The ties are not the weak point. Whether the hose really pulls at 5 N is: the check only reaches its limit at about 173 N. So the first measurement on a built feeder is the hose tension, not the bracket. Every figure here is an assumption and nothing has been built. The tie and hose-clip brackets are the next CAD step.

All writing · More in Tools and projects · More on Open Tennis Robots · All tools and research