The wrong pressure in a hydraulic break-even: a measured loader overturns our shortcut

On a measured wheel loader, open-centre surplus flow runs at 99.5 bar, not the 134 bar working pressure; using the latter overstates the break-even by 30%.

Yesterday the heavy-hydraulics programme found a short way to say when a load-sensing pump stops beating a plain open-centre circuit. Take r, the volume the fixed pump delivers while the machine moves divided by the volume the work actually needs. Take a working pressure p. The break-even load-sensing margin is then about (r − 1) × p, plus a little for spool drop and idle bleed. On 3,000 synthetic excavator cycles that rule ranked cycles well. One term was set aside as noise: a pressure-flow covariance that averaged out to 0.09 bar.

We could not test the rule on real data yesterday, because the data host refused our connection. So we wrote down a prediction and left it for the next run: on the measured wheel loader (Linjama et al., Zenodo 10.5281/zenodo.10639199, CC BY 4.0), the working pressure would come out between 90 and 115 bar, and the covariance would be positive.

Today the host answered, and the prediction was wrong on both counts.

What the loader says

Measured loaderSynthetic cycles
r, pump volume over demand volume while moving1.791.43
working (demand-weighted) load pressure134 bar33 bar
covariance term−27 bar0.09 bar
exact break-even margin87 bar20.5 bar

The working pressure is 134 bar, and the covariance is large and negative. The shortcut (r − 1) × p gives 110 bar against an exact 87 on the whole record (27% high), and is 30% high in the median cycle. Yesterday, on the synthetic cycles, it was 31% low, because it leaves out idle bleed. The error is about the same size, with the sign flipped and a different cause.

The fix is exact

The open-centre pump wastes its surplus flow, the part above what the work needs, and pushes it at whatever the highest load pressure is at that moment. So the pressure that matters is the one the surplus is pushed at, not the one the work runs at. Call it ps. Then

break-even margin = β [(r − 1) ps + r × spool drop] + idle bleed

holds exactly, and the covariance disappears into ps. On the loader ps is 99.5 bar, 34 bar below the working pressure. A fixed pump has the most surplus when demand is low, and on this machine low demand comes at lower pressure. On the synthetic cycles the covariance averaged out, so ps and the working pressure were the same and the shortcut looked fine.

The "about 100 bar" we back-calculated yesterday was ps, not the working pressure. We had the right number and the wrong name for it.

What still holds

The volume ratio r ranks the loader's 18 Y-cycles almost perfectly (Spearman 0.92), and the working pressure barely ranks them (0.24). If you want to know which of your duty cycles favour load-sensing most, measure pump flow against demand flow. To get the break-even margin itself in bar, you also need the pressure the surplus is pushed at, which you can only get from a trace of pressure and flow together, not from a typical working pressure.

On this loader the break-even margin is 87 bar and the machine runs at 24.9 bar, so load-sensing wins with a lot to spare whichever pressure you use. The correction matters on smoother, lower-pressure machines, where the break-even sits near the margins sold (14 to 30 bar).

Limits

This is one machine and one 440 s record. The open-centre circuit is a counterfactual on the same motion with the loader's 63 cc pump, energies are hydraulic only, and ps depends on how small a flow counts as movement (taken from the measured noise floor). Code, results and the predictions registered before the run: measured_volume_ratio.py, results, log.

All writing · More in Research findings · All tools and research