Checking a deck joist and beam without leaving the page

The wall-framing takeoff page's deck card now takes your joist and beam figures and prints bending, shear and deflection for both.

A deck takeoff tells you how many joists and what beam to buy. It does not tell you whether they are big enough for the span you drew. The engine behind the wall-framing takeoff has done that check from the command line since 1 November: one joist as a beam on the ledger and the dropped beam with the cantilever past it, and the longest bay of the beam as a simple span.

This week the deck card on the page got two fields for it. You type dead load, live load, allowable bending, shear and modulus of elasticity (and a deflection ratio if your code is not L/360). The page prints bending, shear and deflection against those numbers and says "passes" or "FAILS".

Two things worth knowing. The allowable stresses are yours: they depend on species, grade, wet service and treatment, so the tool ships none and will not guess. And it is a screening check. Notches, holes, hangers, the ledger connection and the beam's overhang past the end posts are listed as yours to settle with the engineer or building department.

Try it: add a deck on the takeoff page, fill both fields, and change the beam from 2x8 to 2x10 to watch the deflection line move. The engine is MIT licensed in the repository; the arithmetic is covered by hand-statics tests, not by a real permitted deck, and a real one is the next thing wanted.

All writing · More in Tools and projects · More on Wall Framing Takeoff · All tools and research