Can your screen hold a 10% halftone dot?

A halftone film generator for screen printing in the clothing studio, with the mesh-versus-lpi check that stops dots breaking up.

A photo on a T-shirt needs halftones: the tone of each ink layer becomes dots, big in the shadows, small in the highlights. Two things go wrong at the screen, not on the computer. A mesh that is too coarse for the line count breaks the dots up, and dots under about 10% (or over about 90%) fill in or fall out.

The clothing studio now has halftone.mjs. It takes one ink layer, a line count (lpi), an angle and the printed width, and makes an SVG film in millimetres. A mesh of 230 holds about 51 lpi (mesh divided by 4.5); ask for 55 lpi on a 110 mesh and it says to use a finer mesh or fewer lines. Highlights under 5% are cut and counted, so the brief says how many dots were left off. Several inks get angles that avoid moire.

Checked on a flat 50% grey (the dots cover half the film), a gradient (dots grow toward the dark side) and a 30 degree grid (every dot inside the film). These are rules of thumb; strike a test with your printer's mesh and ink. It is not on the page yet; wiring it to the colour separation is next.

All writing · More in Tools and projects · More on Clothing Design Studio · All tools and research