Framing a shed-roof wall: one slope, no peak

The wall framing takeoff now frames a single-slope wall: studs that rise with the roof, plates cut along one slope, and a check against hand arithmetic.

A gable end has a peak in the middle. A shed-roof wall has its high point at one end, so the studs grow steadily from one side to the other.

wall-framing-takeoff framed gables only. A peak at the wall's end was refused, and the maths divided by the distance from the peak to the far end, which is zero. A wall with "gable": {"pitch": 4, "peak": 192} on a 192 in wall now frames as one slope.

Checked by hand: 4 in of rise per 12 in over 192 in is 64 in, so the tallest stud is the plan's stud length plus 64 in. The top plate runs 192 x sqrt(1 + (4/12)^2), about 202.4 in along the slope. Both are asserted in engine.test.mjs.

Sheathing and siding run on the wall without producing NaN or infinite values. The page does not offer it yet, and no real shed-roof plan has been tried. A peak that is not at the end but is too close to it is still refused.

All writing · More in Tools and projects · More on Wall Framing Takeoff · All tools and research