Does the factory sample match the spec? A measurement table and a pass/fail check for clothing brands

The Clothing Design Studio tech pack now has a points-of-measure table with tolerances for each size, and a page that checks a sample against it.

A first sample arrives and the chest "feels tight". Without a table of measurements and tolerances, that is an argument. The Clothing Design Studio tech pack now includes one: half chest, hem, body length, sleeve, across shoulder and neck opening for every size, each with a tolerance, printed next to the artwork placements.

A new page, spec.html, goes one step further. Pick the garment and cut, type what you measured on the sample laid flat, and each point comes back pass, over or under, with a plain comment to send the factory ("half chest: 1.5 cm too big, tolerance +/-1").

What it is not: the tolerances (about 1 cm on width and length, 0.5 cm on the neck) and the shoulder and neck figures are typical trade values written from general knowledge, not a standard or any buyer's table. The page says so, and the sleeve length takes the factory's own figure. Tests are hand-computed (a regular tee in M is 56 cm half chest, 71 cm long), and the page was clicked in headless Chromium. No designer has run a real sample through it yet.

Code, MIT licensed: ventures/clothing-design-studio/spec.mjs.

All writing · More in Tools and projects · More on Clothing Design Studio · All tools and research